Design And Construction Of A Sequential Device Control Using Tv Remote Control
INSTRUCTIONS:
- You are perusing the project material titled “Design And Construction Of A Sequential Device Control Using Tv Remote Control.”
- The project material on Design And Construction Of A Sequential Device Control Using Tv Remote Control is available for instant download.
- Preview Chapter One of Design And Construction Of A Sequential Device Control Using Tv Remote Control at no cost.
- To access the complete project material for Design And Construction Of A Sequential Device Control Using Tv Remote Control, kindly make a donation to support the ongoing maintenance and operation of this website.
- The provided work on Design And Construction Of A Sequential Device Control Using Tv Remote Control is intended solely for academic research purposes and should be utilized strictly as a set of guidelines.
- Our objective in distributing Design And Construction Of A Sequential Device Control Using Tv Remote Control is to aid individuals unfamiliar with project research, specifically writers seeking assistance in this area.
- Kindly refrain from directly replicating the content provided in Design And Construction Of A Sequential Device Control Using Tv Remote Control materials.
- Feel free to reference “Design And Construction Of A Sequential Device Control Using Tv Remote Control” in your work, provided that you paraphrase appropriately.
- Unauthorized reproduction of Design And Construction Of A Sequential Device Control Using Tv Remote Control content is prohibited under our Terms of Use.
- UniProjects assumes no responsibility if you replicate the content of this Design And Construction Of A Sequential Device Control Using Tv Remote Control.
ABSTRACT
This work is on sequential device control using TV remote control. This device lets one to switch ON and switch OFF up to nine devices sequentially from your TV remote control.
The circuit consists of an IR sensor module TSOP1738, which is equivalent to TSOP1238. The output of TSOP1738 is fed to the trigger input (pin 2) of IC NE555 (IC1) via LED1. IC1 is wired in monostable mode and its output is fed to clock input of IC CD4017 (IC2). All the nine outputs of IC2 are connected to the bases of relay-driver transistors T1 through T9 that controls the loads via resistors R7 through R15, respectively. Relays RL1 through RL9 are connected between the positive terminal of 12V and collectors of respective transistors.
TABLE OF CONTENTS
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
TABLE OF CONTENT
If you’re referencing specific information, quotes, or ideas from “Design And Construction Of A Sequential Device Control Using Tv Remote Control”, provide a citation in the appropriate format such as APA, MLA, or Chicago.
The title page of downloaded document contains information about the author, editor, and publisher of Design And Construction Of A Sequential Device Control Using Tv Remote Control material.
Select “Donate & Download,” on top of “Design And Construction Of A Sequential Device Control Using Tv Remote Control” and upon completing your donation, you will be directed to the download page or you can chat with us for alternative donation methods.
You have the opportunity to upload content similar to “Design And Construction Of A Sequential Device Control Using Tv Remote Control” and receive payment for each download of the material. Engage in a conversation with our representative if you have any topics related to Design And Construction Of A Sequential Device Control Using Tv Remote Control.