Audio Visual Ir Sensor Tester
INSTRUCTIONS:
- You are perusing the project material titled “Audio Visual Ir Sensor Tester.”
- The project material on Audio Visual Ir Sensor Tester is available for instant download.
- Preview Chapter One of Audio Visual Ir Sensor Tester at no cost.
- To access the complete project material for Audio Visual Ir Sensor Tester, kindly make a donation to support the ongoing maintenance and operation of this website.
- The provided work on Audio Visual Ir Sensor Tester is intended solely for academic research purposes and should be utilized strictly as a set of guidelines.
- Our objective in distributing Audio Visual Ir Sensor Tester is to aid individuals unfamiliar with project research, specifically writers seeking assistance in this area.
- Kindly refrain from directly replicating the content provided in Audio Visual Ir Sensor Tester materials.
- Feel free to reference “Audio Visual Ir Sensor Tester” in your work, provided that you paraphrase appropriately.
- Unauthorized reproduction of Audio Visual Ir Sensor Tester content is prohibited under our Terms of Use.
- UniProjects assumes no responsibility if you replicate the content of this Audio Visual Ir Sensor Tester.
Most of the Remote control systems use TSOP 1738 IR Sensor module to control various functions. This IR Sensor is highly sensitive and may damage easily, if is supply voltage increases above 6 volts. This tester is useful to check the working of the IR Sensor. It gives audio-visual indications when the IR sensor is working properly.
TSOP 1738 is designed to sense 38 kHz pulsed infrared rays used in remote handsets.
The IR Sensor has a PN photodiode and a preamplifier stage encased in an epoxy case. The case acts a filter and allows only IR rays to pass through it. The sensor is equipped with an AGC, band pass filter, a demodulator and a control circuit. The output of the sensor has a bipolar transistor with 80-100 K resistor in its collector. The output gives 5 volts at 5 mA current in the standby mode and the output sinks current when the sensor gets pulsed IR Rays. This sensor is capable of continuous data transmission up to2400 bps or more. The band pass filter and AGC circuits suppress unexpected noise to prevent false triggering. The sensor responds to the IR rays only if the carrier frequencyis close to the centre frequency of the band pass filter.
Fig. 1: Image of TSOP 1738 IR Sensor
The IR Sensor tester is powered by two 3 volts lithium cells. The sensor module is tested using the Test socket. Alternately you can use 3 mini alligator clips for on board testing. When the switch S1 is turned on, LED and buzzer remains off, if the IR sensor is good. When the remote handset is focused on to the sensor, and any of the buttons is pressed, LED blinks in sympathy with the pulsed IR rays and buzzer beeps. This indicates that the sensor is good.
A good sensor will give high output when it is not receiving IR rays. This high output makes the cathode of LED and the negative of buzzer high and they remain off. When the output of the sensor turns low by receiving the IR rays, LED and buzzer turns on.
Fig. 2: Image of a Button Cell Battery
Use a 3-12 volt mini buzzer and 3 mm LED to make the gadget compact. It can be enclosed in a small case.
If you’re referencing specific information, quotes, or ideas from “Audio Visual Ir Sensor Tester”, provide a citation in the appropriate format such as APA, MLA, or Chicago.
The title page of downloaded document contains information about the author, editor, and publisher of Audio Visual Ir Sensor Tester material.
Select “Donate & Download,” on top of “Audio Visual Ir Sensor Tester” and upon completing your donation, you will be directed to the download page or you can chat with us for alternative donation methods.
You have the opportunity to upload content similar to “Audio Visual Ir Sensor Tester” and receive payment for each download of the material. Engage in a conversation with our representative if you have any topics related to Audio Visual Ir Sensor Tester.